Meyra 2.432 Specifikace stáhnout pdf (Strana 22)

22

FUSES

Replacing a defective safety fuse

Main safety fuse for the battery cir-

cuit:

Blade-type electric fuse:

The blade-type electric fuses for the bat-

tery power supply are inserted in the

appropriate fuse holder on the battery

cover (Fig. 57).

Note!

Only replace the

safety fuse

with a

safety fuse

of the same type!

Remove the blade-type electric fuses

from the fuse holder and replace them

with new ones.

Note:

New safety fuses are available at all

petrol stations.

If the safety fuse blows again, take the

battery to your specialist dealer for re-

pair.

FAULT CLEARANCE

If treated properly, your wheelchair will

not malfunction. To ensure that your

wheelchair gives you many years of ser-

vice, especially if it is your first electronic

wheelchair, we have listed possible

faults and remedial action to be taken in

the following table.

We recommend that an

inspection

is

carried out every 2 years to permit the

early recognition and clearance of faults

which are not listed in the table. The

following inspection certificates should

then be stamped by your specialist dea-

ler.

Note!

Work on the internal mechanics of the

joystick and electronic parts should

only be carried out by a

specialist

workshop

.

The mechanics of the joystick should

never be oiled but completely repla-

ced!

Cause

A main safety fuse (blade-type electric

fuse) for the battery circuit is defective or

not inserted firmly enough.

The plug is loose.

The batteries are fully discharged.

The battery display is malfunctioning.

The batteries are almost fully dischar-

ged.

The batteries are defective.

The brake release lever is set to push

mode.

Fault

Battery display (19) does not light up

when the wheelchair is switched on.

LED 1 on the battery display (19) is

flashing 1 x per second.

Battery display (19) is flashing 2 x per

second.

Wheelchair does not move forward.

Clearance

Change the blade-type electric fuse or

insert it properly.

Check the plug to ensure that it is pro-

perly connected.

Recharge batteries immediately.

Have them checked by a specialist

workshop.

Send to a specialist workshop for re-

pair.

Recharge batteries immediately.

Have them checked by a specialist

workshop.

Send to a specialist workshop for re-

pair.

Move the brake release lever to drive

mode.

SERVICE

FAULT CLEARANCE

Lighting fuse

The supplementary box contains the fol-

lowing fuse (E, Fig. 60):

– 4A ø5x20 mm fine-wire fuse (glass

tube).

Before replacing the fuse remove con-

nector plug (B, Fig. 62).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Komentáře k této Příručce

Žádné komentáře