Meyra 2.432 Specifikace Strana 13

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 38
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 12
13
GB
BACKREST
Removing the back
Loosen the screws via hand wheel
(A, Fig. 26)
Lift up the back (Fig. 27)
Mounting the back
Push the back tubes into the appro-
priate receptacle from above.
Tighten the screws via hand wheel
(A, Fig. 26)
Check to ensure that the back is secu-
re.
FOLDABLE BACKREST CODE 820
The backrest (2) can be folded back at
the level of the armrest (Fig.28).
Benefits:
Enhanced mobility of the upper body
Lower wheelchair height for storage
of the wheelchair
Folding down the back
Push down the side release lever (A,
Fig. 29) on each back tube
Fold down the back (Fig. 28)
Folding up the back
Folding up the back
Lift up the release lever (A) to a hori-
zontal position (Fig. 30)
Check that the release lever is lok-
ked in place.
Benefits:
Simple adjustment to suit your perso-
nal requirements
Reduces muscle tension in the shoul-
der region through individual fitting
If a seat cushion is used, the armrests
can be adapted to the new seating
level.
Handling:
Loosen adjustment screw (A, Fig.
25).
Position the armrest at the required
height (but no higher than the guiding
mark).
Note!
Danger of crushing!
Tighten the adjusting screw (A, Fig.
25)
Mounting the side parts
Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the
wheelchair from rolling away acci-
dentally.
Insert the side parts as far as they will
go in the appropriate guides and
secure by way of the adjusting
screw.
Note!
Danger of crushing!
ADJUSTABLE BACKREST CODE 632/
633
The tensioning of the backrest is adjusta-
ble (Fig. 20).
Remove the back cover and fold it
forwards.
Open the Velcro fastener of the belt
that you wish to adjust and close it
again after adjustment.
Note!
The overlapping of the Velcro fastener
has to be at least 10 cm!
ARMRESTS
Zobrazit stránku 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Komentáře k této Příručce

Žádné komentáře